Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-14-2001, 01:51 AM
|
#23 |
|
The Photoshop Guru
Join Date: Feb 2001
Location: Mecca, Indiana
Posts: 1,419
|
So am I just wasting my time screwing around with these stock heads? I didn't want to spend any more than I had to on them because I was wanting to go with some aluminums when the cash flow permitted.
If I went with GT-40 irons my headers would still bolt up wouldn't they? And are they a direct bolt on? How much HP would I gain using those over the stock ported heads with this combo? Thanks! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ARP assembly lube and thread sealer.??? | JaxMustang50 | Windsor Power | 4 | 04-15-2003 10:18 AM |
| Dan..close This Thread..just My 2 Cents | Topless In Texas | Blue Oval Lounge | 8 | 08-02-2002 06:43 AM |
| "Why's my car so slow" Thread Deleted... | Hammer | Modular Madness | 23 | 07-09-2002 05:12 PM |
| Shift Knob Thread Size | Gautam | Blue Oval Lounge | 1 | 02-19-2001 12:48 AM |