Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-13-2001, 03:27 PM
|
#4 |
|
Registered Member
Join Date: Sep 1999
Location: Minneapolis, MN
Posts: 121
|
Your speed density system runs itself gauged by the vaccuum in the motor. When you put the e-303 in you dropped the vaccuum and the computer is speaking english but trying to read Chinese-has no idea what to do so it just decides to run crappy. The only way I've seen to correctly cure this is to go to a dyno and get a chip burnt for your car. At WOT their is no vaccuum no matter what cam you run so that is why it works fine then-it's set up to run that way.
------------------ 1988 GT-under construction |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tuning a speed density system with mods | Fostang | Windsor Power | 6 | 07-10-2002 11:32 PM |
| Idle problem 88GT Speed Density | chuck88 | Windsor Power | 9 | 07-07-2002 09:16 AM |
| First ticket. Sucks, sucks bad. | zepherman | Blue Oval Lounge | 46 | 12-16-2001 07:24 PM |
| EFI conversion with Speed Density and a 351w? | PSI GUY | Windsor Power | 2 | 12-02-2001 11:13 PM |
| speed density question.. | bobtodd | Blue Oval Lounge | 2 | 04-15-2001 02:03 AM |