Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-17-2001, 09:44 PM
|
#7 |
|
Registered Member
Join Date: Aug 2000
Location: Thousand Oaks, CA
Posts: 396
|
Well, I didn't get it done today. Cam is in, I need to check it and make sure it's lined up right tomorrow. I've been taking a little time and painting brackets and valve covers, cleaning up the wiring a little.
I have a question on re-installing the timing chain cover - is there some kind of trick to getting the cover back on without my oil pan gaskets sliding off or not lining up when I push it over that key on the bottom right hand bolt of the cover? |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Attn: Houstoner's~my Car Club's Fall Show This Saturday! | Topless In Texas | Blue Oval Lounge | 0 | 08-25-2002 11:33 PM |
| LS-1 SS Camaro driver Claimed 360 RWHP Saturday. | Mercury | Blue Oval Lounge | 32 | 02-21-2002 02:34 AM |
| My car was Temporarily Borrowwed Saturday night. | Mercury | Blue Oval Lounge | 17 | 02-20-2002 12:48 AM |
| E303 vs 2031 | TEXSN95 | Windsor Power | 10 | 05-20-2001 01:35 AM |
| New 2031 cam, idle questions | withamc | Windsor Power | 5 | 02-26-2001 11:36 AM |