Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
02-18-2001, 05:07 PM
|
#1 |
|
Registered Member
Join Date: Dec 2000
Location: roseburg, oregon
Posts: 87
|
What I do is scrap the main parts of the old gaskets off and use my wire wheel to surface the block and heads to get rid of any stuck gasket stuff. Then I use an old shop vac. and suck up all the gasket material that flew everywhere. You know in the cylinder walls and what not. Then I use a rag and wipe everything clean.
|
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Distributor Question Please Help | NitroNixon | Windsor Power | 3 | 10-07-2002 05:21 PM |
| GT40 crate engine question | dlb1982 | Windsor Power | 2 | 09-24-2002 09:42 AM |
| Question about rebuilding engine | setherek | Classic Mustangs | 3 | 09-22-2002 10:41 PM |
| Engine Shifting into radiator and also clucth broke | Stuffie0912 | Classic Mustangs | 2 | 12-03-2001 03:26 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Small Ponies | 0 | 05-12-1999 02:27 AM |