Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-16-2001, 12:00 AM
|
#4 |
|
Registered Member
Join Date: Feb 2001
Location: Pensacola, FL, USA
Posts: 36
|
Your best bet is probably with the WD-40 as mentioned above. However, if it's only a small amount of glue (emblems...) and you don't have any WD-40 lying around, you can always use some hot water, car wash solution, and elbow grease.
------------------ 1991 LX 5.0 Convertible: AOD w/ shift kit, Steeda 3-pc. chassis stiffening kit, 4-pt. AutoPower roll-bar, the K&N, MAC shorties and cat-backs, 3.73's. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Throttle Body & Idle Conrol Valve Info | BigBobsL | Windsor Power | 2 | 02-10-2004 01:16 AM |
| Saleen Body Kits - good or bad? | subterfuge | Modular Madness | 5 | 06-26-2002 10:55 AM |
| Will A Throttle Body Do Much For Ya With Minor Mods? | steedamustang01 | Modular Madness | 15 | 04-15-2002 10:38 PM |
| Body side moulding | Shotgun28 | Windsor Power | 6 | 05-23-2001 05:52 PM |
| How to remove body trim...... | Shotgun28 | Windsor Power | 8 | 01-08-2001 06:45 PM |