stereo question

[Power]

Originally posted by JL1314:
head unit goes to eq(if you have one), then goes to crossover, then to amps, then to speakers! Good luck!

This pretty much covers it.

Originally posted by old guy with 87 gt:...depends on what type of cross overs....if there low level (rca type jacks)then they will get hooked up before amps, sub output going to subs amp,hi pass or mid pass going to speakers amp.But if its a hi level crossover set up or in line block set up it would go in speakers lines...

Also right on the money.

I am assuming you don't have passive crossovers or you would be asking more questions about "those little doohickeys".

So, making sure you go "In's to Out's" and vice versa down the chain you should be good. Head unit outs to the Crossover Ins etc. Just make sure you don't mix up the Outs on the cross overs.

What are you using for door speakers and subs? What size amps did you get? Was everything hooked straight up(i.e. no bridging, crossed terminals)?

Hope you get it back together good.


[This message has been edited by Power (edited 05-22-2001).]

[This message has been edited by Power (edited 05-22-2001).]