MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Reload this Page Stock intake, mass air, and throttle body
Register FAQ Members List Calendar Mark Forums Read

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 02-25-2001, 11:00 PM   #3
rtz
Registered Member
 
rtz's Avatar
 
Join Date: Feb 2001
Location: Edmond, OK
Posts: 180
Post
I was going to build a "high compression" N/A motor, then if that "wasn't enough", I was going to add a blower.

Could I safely add a "small" 5 - 8 psi blower to a 10:1 block with the stock bottom end? Would it take it and would it work out ok?
rtz is offline   Reply With Quote
 

« Previous Thread | Next Thread »

Thread Tools
Display Modes Rate This Thread
Threaded Mode Threaded Mode
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 08:03 PM.

Archive - Top

SEARCH