Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-27-2001, 09:41 PM
|
#4 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
as far as i know, you have to put it on the intake, just look at your stock one and put it about the same place as it, its on the #1 intake runner on the lower intake, i just fisnished this install and everything went pretty well, now that i think of it since you got a cobra lower it may already be tapped for the sensor but maybe not, good luck with it
------------------ 88 Notchback 5.0, 3.73's, pulleys, BBK headers, off-road H-pipe, flowmasters, subframe connectors, 65mm TB, shift kit, March ram air kit, motorsport wires, MSD coil, upper and lower control arms, 155lph fuel pump, cheap 2800 stall, Crane Adj.FPR, best time- 13.99@99.75, not yet tested times after 1.7RR install  |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| explorer intake and mass air? | canukracer | Windsor Power | 1 | 07-30-2003 07:56 PM |
| trickflow intake install | StripedStangLX | Windsor Power | 7 | 03-12-2002 02:01 PM |
| Car is now backfiring after intake install | leo | Windsor Power | 3 | 03-30-2001 09:53 AM |
| Explorer intake install | leo | Windsor Power | 0 | 03-26-2001 04:06 PM |
| explorer intake??? | joey50gt | Windsor Power | 5 | 02-25-2001 10:20 PM |