Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-23-2001, 07:46 PM
|
#9 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
The Fox body used both the 3.35, and the 2.95 1st gear ratio's.
I'm pretty sure the extra length is all related to the crossmember mounting on the SN95's being a little different. The input shaft on the SN95 cars is 7.85", the input shaft on the Fox is 7.18". So the bellhousing is also different, has to be longer to use the extra 3/4" of input shaft. Swapping the input shaft and the front bearing retainer would enable you to convert an SN95 T-5 to 83-93 specs for fitment. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| raced a Supra Twin Turbo | Stang35th | Stang Stories | 63 | 08-23-2003 12:36 AM |
| what size engine stand bolts? | 82 GT | Windsor Power | 2 | 06-25-2003 11:13 PM |
| Stupid Question? | SilverGT02 | Modular Madness | 4 | 07-06-2002 11:01 AM |
| Engine Size | zach0 | Classic Mustangs | 5 | 08-28-2001 11:19 PM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |