explorer intake here, a few Q's on install

Patrick Boetticher · 02-26-2001, 11:21 PM

On my manifold (early 96) on the upper, it had four vaccume lines on it. the lower had some extra holes in it. it had one in one of the intake runners (for the AIT) the others were for a coolant thing.. ipluged them all up. there was also another hole on the front bottom of the upper intake that i also plugged... i dotn know any thing about the EGR cuz on 95s all i need is the elbow adapter and every thing bolts up... any questions.. ill try to help..

------------------
PPG Torch Red 95GT, Ported Explorer Intake, E-303 cam, 75mm MAS, BBK Adj. fuel Reg & gauge, BBK Shorty Headers, BBK H-pipe, March Pulleys, 2 Chamber Flowmasters, Kenny Brown 6 point Roll cage, Kenny Brown Panhard Bar, Powerslot Rotors, Eibach Sportline Springs, 180* Thermostat, 1/2 Plenum Spacer, MSD 6AL, MSD Master Blaster, MSD 8.8 Wires, 19# Racing Injectors, AFS 10.5" Cobra R's, Nitto 555's, Eclipse & JL Stereo System... I just sold My K&N, It looks funny with Stock Air Box & filter!!!

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
explorer intake and mass air?	canukracer	Windsor Power	1	07-30-2003 07:56 PM
trickflow intake install	StripedStangLX	Windsor Power	7	03-12-2002 02:01 PM
Explorer intake install	leo	Windsor Power	0	03-26-2001 04:06 PM
Explorer intake install	leo	Windsor Power	3	02-27-2001 09:41 PM
explorer intake???	joey50gt	Windsor Power	5	02-25-2001 10:20 PM

02-26-2001, 11:21 PM	#6
Patrick Boetticher Registered Member Join Date: Feb 1999 Location: Camarillo/Thousand Oaks Ca Posts: 223	On my manifold (early 96) on the upper, it had four vaccume lines on it. the lower had some extra holes in it. it had one in one of the intake runners (for the AIT) the others were for a coolant thing.. ipluged them all up. there was also another hole on the front bottom of the upper intake that i also plugged... i dotn know any thing about the EGR cuz on 95s all i need is the elbow adapter and every thing bolts up... any questions.. ill try to help.. ------------------ PPG Torch Red 95GT, Ported Explorer Intake, E-303 cam, 75mm MAS, BBK Adj. fuel Reg & gauge, BBK Shorty Headers, BBK H-pipe, March Pulleys, 2 Chamber Flowmasters, Kenny Brown 6 point Roll cage, Kenny Brown Panhard Bar, Powerslot Rotors, Eibach Sportline Springs, 180* Thermostat, 1/2 Plenum Spacer, MSD 6AL, MSD Master Blaster, MSD 8.8 Wires, 19# Racing Injectors, AFS 10.5" Cobra R's, Nitto 555's, Eclipse & JL Stereo System... I just sold My K&N, It looks funny with Stock Air Box & filter!!!