Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-30-2001, 05:19 PM
|
#9 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
If you are going to put them on a Boss 302 or if you plan on selling them on Ebay, go for it. Like was just posted, they are worth way more than that.
If you plan on keeping fuel injection, don't try. The intake manifolds are different from Boss to Windsor, no EFI intakes for it. It actually won't make much power below 4000rpms. Revving an engine to the powerband those heads were built for will nix a hydraulic valvetrain in favor of a solid lifter setup, and a carb, not EFI, a different crank, rods, and a lot of other **** . |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GT-40 heads | 5.0 Pony | Windsor Power | 1 | 09-10-2002 10:26 PM |
| Boss Pistons For 347 Stroker | Ford_Racer_1 | Windsor Power | 3 | 09-09-2002 05:39 PM |
| val springs in stock 97 heads , quesion ? | southernstang97 | Modular Madness | 0 | 07-16-2002 11:52 AM |
| My NEW replacement Holley heads are different! | Rick 91GT | Windsor Power | 8 | 04-23-2001 06:45 AM |
| Which heads are beter? | patman | Classic Mustangs | 3 | 12-02-1999 03:42 AM |