Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-01-2001, 01:36 AM
|
#18 |
|
The Photoshop Guru
Join Date: Feb 2001
Location: Mecca, Indiana
Posts: 1,419
|
I would go with the BBK's if I had to do it over again. I've heard they are a lot easier to install than the MAC L/T's, and the finish holds up better. I have some pics somewhere and will try to get them scanned for you if I can find them.
I need to get a new steering shaft because mine hits on the header at the coupler. I think once I get my new motor mounts in it will alieviate that though. That's another thing... Get a set of motor mounts for a convert and replace those while you are doing the header install. They are a lot stronger and since you'll be down there it's a good time to do it. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Long Tubes for AOD | Mustvid | Windsor Power | 4 | 09-18-2003 09:29 AM |
| Headers - Shorties or Long Tube? | SleeperGT | Modular Madness | 6 | 03-07-2003 11:19 AM |
| TFS High Ports and Long Tubes | HORSEMEN RACING | Windsor Power | 3 | 07-16-2002 12:57 PM |
| exhaust: shorties or long tubes? | 1mintlx | Windsor Power | 3 | 04-03-2001 09:14 PM |
| 1 3/4 Hooker Long Tubes vs Shorties results! | 8850 | Windsor Power | 2 | 02-04-2001 12:42 AM |