Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-15-1999, 01:42 AM
|
#3 |
|
Registered Member
Join Date: Sep 1999
Location: Murfreesboro, TN
Posts: 56
|
Oh horse hockey!! I ran nitrous on the same motor for 6 years without a hitch and would still be running today had I not pulled it to put in a new motor. theres no tellin how many bottle went through that thing. Nothing special either just a stock cast piston motor. I would install a high volume fuel pump, And an MSD window switch and bottle the hell out of it, with no worries in the world. Main thing is to not over-rev it or get it into detonation. the cams can come later with a full build up as right now I just think they would hurt you.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aftermarket Mod Cams | SLOW 97 | Modular Madness | 15 | 03-20-2002 09:53 AM |
| how can you tell apart 99 heads and cams and 98 heads and cams | 98 NosStang | Modular Madness | 5 | 09-25-2001 11:51 PM |
| crane cams survey | BurninBurt | Modular Madness | 0 | 06-05-2001 11:47 AM |
| Question on CAMS for my 4.6L...... | QuickSilver96 | Modular Madness | 0 | 12-12-1999 07:12 PM |
| Question concerning HEADS and CAMS...... | QuickSilver96 | Modular Madness | 0 | 12-12-1999 02:16 AM |