Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-05-2001, 03:36 PM
|
#3 |
|
Registered Member
Join Date: Aug 2000
Location: santa ana ca
Posts: 1,349
|
I believe that setup is for a fox, I have an SN95 5.0 Still I have heard that they are actualy worse than the stock setup because they suck up heat from the motor (which kinda eliminates the "cold" in "cold air induction" Im thinking about saving the cash for a GT40 intake but if this will really help then Im gonna buy it too.
------------------ 95GT B303 cam, 1.7 rockers, 65mm TB, 73mm MAF, milled heads, 355's K&N, off road pipes, pulleys, msd coil, 9mm wires, Tremec 3550, Pro5.0 shifter,10.5 Motorsport clutch, FMS aluminum driveshaft, weld in subframe connectors |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WHY is a 80mm MAF and cold air induction a bad combination?? | 96_4.6 | Modular Madness | 6 | 03-09-2003 02:19 AM |
| Cold air induction | StangGT02 | Modular Madness | 5 | 07-14-2002 03:32 AM |
| Cold cold air induction!!!!!! | 01 BLACK GT | Modular Madness | 3 | 07-18-2001 02:10 PM |
| Cold Air induction.... $7.83 | rbatson | Blue Oval Lounge | 6 | 02-25-2001 01:27 AM |
| cold air induction kit | Brett_C | Small Ponies | 0 | 05-03-1999 05:34 PM |