Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
12-08-1999, 09:24 AM
|
#1 |
|
Registered Member
Join Date: Dec 1998
Location: Charlotte
Posts: 435
|
96GTS, how did you get the damn dust covers off the old struts?!? I'm installin Tokico 5 ways, and I cannot figure out how to get the dust covers off. I got the passenger side strut off last night (laying on garage floor). Should I have loosened the big bolt on the top while it was still attached?
Help me out, will ya? Thanks! ------------------ 96 GT: KB subs, March pulleys, Bassani X pipe, 3.73's, alum. drive shaft, 70mm TB, K&N, KB Carbon Kevlar BP, Steeda Tri-ax shifter, Flowmasters, MSD wires H&R springs, Tokico Illuminas,MM C/C plate & GW RLCA sitting in the garage waiting for a free weekend... |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rattling noises comming from my bell housing | leathal injection | Windsor Power | 1 | 06-09-2004 09:35 PM |
| Mustang struts and shocks | Matt Erich | Modular Madness | 2 | 02-24-2004 11:16 PM |
| Differences in Struts | Joe50 | Corner Carvers Delight | 3 | 07-23-2003 09:01 PM |
| Differences in struts? | Joe50 | Windsor Power | 1 | 06-03-2003 06:28 AM |
| STRUTS AND SHOCKS | 89FHPLX | Windsor Power | 4 | 02-27-2001 11:35 PM |