Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-06-2000, 02:11 PM
|
#5 |
|
Registered Member
Join Date: Jan 2000
Location: Ogden Utah
Posts: 58
|
It took me a couple of hours to install with having to route the line from the bottle in the trunk to the engine compartment. Also check to see if you can put a couple of thin washers on either side of the injector nozzle that goes into the air intake. I didn't like the idea of tightening the fittings onto rubber.....Good luck, let me know how it goes........
------------------ |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pathetic dyno results, NA vs nitrous | fiveohpatrol | Windsor Power | 7 | 09-30-2002 01:05 PM |
| My Norwalk Nitrous results - time to rebuild the rear end! | Mike Souslin | Windsor Power | 6 | 07-18-2002 09:31 PM |
| Comments on this Nitrous System | 93boss | Windsor Power | 3 | 03-20-2002 05:19 PM |
| WOO HOO! RAN NITROUS AT TRACK! (long, real long) | bark3rd | Modular Madness | 26 | 08-20-2001 08:05 AM |
| I need a crash course in NITROUS ED | Dark_5.0 | Windsor Power | 7 | 07-12-2001 06:03 PM |