Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-03-2000, 04:41 PM
|
#6 |
|
Registered Member
Join Date: Jul 2000
Location: Baltimore, MD
Posts: 516
|
I have the BBK kit and haven't had any problems except for the speed bumps of course. Looks great after it's been dropped. I have a side pic on my profile. Check it out. You may want to drop your back end down farther if you want an even stance and you drag a lot. Just helps a little more when throwing all that weight to the rear.
------------------ 1997 Cobra, C+L 80mm MAF, Pro 5.0 shifter, BBK Springs, Taylor Wires, 2 Chamber Flows, ASP Pulleys, MAC off road H pipe. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New 4cyl Springs or Lowering Springs? | raptor | Windsor Power | 17 | 02-25-2004 06:48 PM |
| stocks springs vs. lowering springs | GhettoPop | Windsor Power | 1 | 02-12-2004 07:08 PM |
| lowering springs | my9250GT | Windsor Power | 5 | 03-05-2003 01:18 AM |
| Lowering my '96 - Springs? | ncbflo | Modular Madness | 1 | 06-30-2001 09:27 AM |
| Edelbrock/Eibach lowering spring vs. Eibach lowering springs - diff.? | green94droptop | Windsor Power | 1 | 06-16-2001 02:20 AM |