Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
01-24-2001, 09:20 AM
|
#1 |
|
Drag Racer!
Join Date: Nov 1999
Location: Lake Worth, FL USA
Posts: 757
|
Just a side note for those of you looking at sub frames. I've seen the round tube design rip off the dog ears that are welded to them. The square tube design seems to be structurally better and off more support. Just my opinion based on my past experience.
------------------ 00 GT, MAC Offroad H, Pullies, 4.10’s, Flows, UPR shifter, subframes, LCA’s, air filter, Weld Pro Stars, Nitto DR’s 13.19@103.86 (1.82 60ft) 244.6 RWHP M/M 100 88 LX coupe X-FHP, 12pt Cage, UPR K-member, 31 spline rear, full spool… |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help with subframes | Rocket 99GT | Modular Madness | 1 | 02-13-2002 05:18 PM |
| Welding in subframes and removing front sway bar . What should I run?? | Dark_5.0 | Windsor Power | 4 | 10-27-2001 03:06 AM |
| Mac Subframes and Control Arms?? | jrfaraci | Windsor Power | 1 | 07-08-2001 07:55 PM |
| Round tube subframes for 87-93? | Mad Horse | Windsor Power | 7 | 04-02-2001 09:00 PM |
| bolt-on subframes | stanger8172 | Windsor Power | 2 | 02-16-2001 11:47 AM |