Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-02-2001, 06:25 PM
|
#3 |
|
Registered Member
Join Date: Aug 2000
Location: Torrington, CT, USA
Posts: 145
|
I would reccommmend BBK LT's with matching H-pipe. Just got to www.bbkperformance.com for the P/N. The install is a ***** so you might as well do the long tubes for some good power. The 00 Saleens usually dyno around 240 rwhp, and with the LT's you should be pushing about 255 rwhp, not quite LS1 territory, but a lot closer than stock...
------------------ 2000 GT Conv. 5speed Triple Black Current Mods: K&N, Mobile 1, MagnaPack Cat-Back, Steeda Tri-Ax, GW Subframes, 3.73's. ET: 14.26@98.9 (K&N, Mobile1, Tri-ax) |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SVO Shorty Headers 1-5/8 Question | stangposse | Windsor Power | 0 | 08-07-2003 12:48 PM |
| Buying new headers | TwiLighTBluEGT | Windsor Power | 4 | 04-23-2003 08:55 PM |
| Anyone have problems with MAC headers?? | HiFlow5 0 | Windsor Power | 15 | 05-30-2002 08:30 AM |
| Headers should I or shouldn't I....Need Advice Quick Please | Mustang_GT_90 | Windsor Power | 9 | 05-01-2002 01:16 PM |
| BBK one-piece flange or MAC individual flange long tube headers. | Fox Body | Windsor Power | 10 | 04-03-2001 04:25 PM |