Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-24-2001, 08:14 AM
|
#2 |
|
Registered Member
Join Date: Jan 2000
Location: Warner Robins, GA, USA
Posts: 210
|
It is possible that the left/right selector switch is bad or that you have a loose wire on the back of the switch. I would suggest pulling the switch out and do the following checks:
1. Make sure you have 12V on the common of the left/right selector switch. If you do not your problem is somewhere between the fuse block and the switch. 2. If you do have power on the switch the problem is either the switch, wiring, or motors. But it is unlikely that BOTH of your motors kicked off at the same time. Hope this helps! Good luck! ------------------ '97 Cobra, Rio Red, MAC Cold Air Kit, 3.73s, NGK V-Power BBK H-pipe w/cats (Coming Soon!!) |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Life | bigwhitecobra | Blue Oval Lounge | 41 | 06-10-2004 10:29 PM |
| Mustang Dead Please help | 289 | Windsor Power | 9 | 01-08-2004 01:39 AM |
| Power WIndow ?'s | Coupe Devil | Windsor Power | 5 | 10-23-2001 03:12 PM |
| Electrical power, where to splice? | Chris_H | Windsor Power | 3 | 02-11-2001 08:29 PM |
| mirrors on a '78 mustang II | purple horse | Classic Mustangs | 1 | 02-23-2000 07:56 PM |