Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-18-2001, 10:01 AM
|
#3 |
|
Registered Member
Join Date: Apr 2001
Location: Baltimore, Md
Posts: 35
|
what if i made a box that the evap. sat in with a little fan blowing on it and the air doesn't even go through the evap. just next to it like an intercooler. I think I am going to try it anyway. If it dont work then it dont work. Doesnt hurt too try
Joe ------------------ 01' Black GT 2 chamber Flows Mach 460, Leather 17"thrust wheels, bassanni x-pipe with cats, BBK Cold Air, Steeda pullies and timing adjuster @ 13*, Steeda Satin Shift Knob Tri-ax shifter A pillar Double gauge pod, Auto meter White Phantom Gauges Fuel Pressure and Vac, Richmond 3:73's Steeda Subframe Connectors.Strut Tower Brace 13.41 @ 102.1mph |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cold air induction | Toeclicker | Windsor Power | 5 | 08-01-2003 11:48 PM |
| WHY is a 80mm MAF and cold air induction a bad combination?? | 96_4.6 | Modular Madness | 6 | 03-09-2003 02:19 AM |
| Cold air induction | StangGT02 | Modular Madness | 5 | 07-14-2002 03:32 AM |
| Cold Air induction.... $7.83 | rbatson | Blue Oval Lounge | 6 | 02-25-2001 01:27 AM |
| cold air induction kit | Brett_C | Small Ponies | 0 | 05-03-1999 05:34 PM |