Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
08-27-2001, 03:28 PM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Madison, MS
Posts: 52
|
Can't help on where to get the gears installed as I am in Mississippi but you can either get a new speedo gear or a Speedcal module (I think that is what it is called). the gear will get chewed up but they are cheap. The other plugs into the sensor and harness at the transmission. I think someone asked about this on here somewhere so you might look around to find out the name of that module. I think it is around $100 give or take a few $$! Hope that helps a little
------------------ 96 Crystal White Cobra Coupe 4:10 gears, off-road h-pipe, 2 chamber flowmasters, K&N, pulleys, FMS springs, polyurethane bushing, Steeda Caster/Camber plates |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3.73 v. 4.10 Gears | GTMustang96 | Modular Madness | 20 | 03-20-2003 06:36 PM |
| 4.10 Or 4.30 Gears In 8" Rear? | jimijuggernaut | Classic Mustangs | 4 | 02-28-2003 04:33 PM |
| How good are 4.10 gears and AOD? | KG88GT | Windsor Power | 11 | 02-02-2002 10:34 PM |
| 4.10 gears | swtstang | Windsor Power | 1 | 06-22-2001 06:33 PM |
| whats gears 3.75 or 4.10 with a ZT-5 | terrible0ne | Windsor Power | 2 | 03-24-2001 11:07 AM |