MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Racing > Corner Carvers Delight
Reload this Page Kenny Brown's P-hard bar w/any 2.5!!
Register FAQ Members List Calendar Mark Forums Read

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 01-04-2001, 02:22 PM   #2
turbolx
Registered Member
 
Join Date: May 1999
Location: Detroit, MI
Posts: 252
Arrow
I would not recommend the KB panhard, as it attaches to sheet metal in teh spare tire well instead of the opposite frame rail. This is just asking for stress cracks over time.

Take a look at the Maximum Motorsports piece, MUCH better as far as strength is concerned and should still clear most 2.5" exahust systems. It's even a little less expensive, too...

------------------
Greg Banish
President, Detroit Speedworks, Inc.
'93 LX Turbocharged Road Racer
'00 Bad-Ass F150
turbolx is offline   Reply With Quote
 

« Previous Thread | Next Thread »

Thread Tools
Display Modes Rate This Thread
Threaded Mode Threaded Mode
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
New Control Arms: Mega Bites or Kenny Brown PeTr0 Windsor Power 2 07-11-2002 12:58 AM
Trans Problem car hard to put in gears drtbiker Windsor Power 11 05-06-2002 10:28 PM
wish me luck, I just applied at Kenny Brown! fiveohpatrol Blue Oval Lounge 4 05-26-2001 09:38 PM
HELP on Pan hard Bar Patrick Boetticher Windsor Power 1 03-02-2001 06:12 PM


All times are GMT -5. The time now is 04:39 AM.

Archive - Top

SEARCH