Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-01-2001, 09:45 AM
|
#1 |
|
Moderator
Join Date: Dec 1999
Location: Livonia, MI, USA
Posts: 1,194
|
Yeah, I copied the design off of Griggs and the Mustang Performance Handbook-II (both). Then took the best of both, and made my own.
Mostly, you'll have questions as you get going during the installation.  p.s. While you are at it, order a set of DELRIN bushings from Griggs (if you are doing tubular control arms / k-member). The stock ones arent that great, and they are only $80. ------------------ Darius Rudis Roadracer: Home built t-arm/panhard suspension powered by an S-trimmed motor :-) My Mustang Page |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Gears, Install, and Questions | B2r3y | Windsor Power | 6 | 02-21-2003 05:00 PM |
| A Question for 94-95 owners concerning 1.7RR INSTALL | SlowStang2 | Windsor Power | 6 | 09-22-2001 06:39 PM |
| Any tips on rear assembly/lower cntrl arm install? | LOCASH | Windsor Power | 1 | 04-30-2001 04:35 AM |
| White Face Gauge install tips | DemonGT | Windsor Power | 3 | 04-11-2001 12:25 AM |
| Place for suspension install in CA, near SF | Velvet | Windsor Power | 4 | 02-01-2001 12:44 AM |