Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-06-2001, 08:43 PM
|
#3 |
|
Moderator
Join Date: Dec 1999
Location: Livonia, MI, USA
Posts: 1,194
|
You gotta figure out what you NEED.
Depending on the track and horsepower and what trans gear you wanna run in... I run a 3.73 gear with an S-trim motor. Does fine on local tracks between 3rd/4th. I had it at MIS and ran 5300rpm in 5th! ------------------ Darius Rudis Roadracer: Home built t-arm/panhard suspension powered by an S-trimmed motor :-) My Mustang Page |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear end problems - OUCH! | mysweetlx | Windsor Power | 0 | 09-23-2002 01:40 PM |
| Recommendations on a rear gear ratio | jim_howard_pdx | Windsor Power | 1 | 09-15-2002 12:10 AM |
| question on fuel system and rear gears and launching | vetteeatr | Windsor Power | 1 | 08-12-2001 05:28 PM |
| Gears, need help!!!! | Edgar Negron | Windsor Power | 3 | 05-27-2001 03:10 PM |
| Recall 01S15 Rear Knuckle replacement | folthoff | Special Production | 0 | 05-02-2001 08:28 AM |