Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-16-2001, 10:05 AM
|
#2 |
|
Registered Member
Join Date: Dec 2000
Posts: 168
|
I believe it is only the housing, so yes, you would swap over the sensors/tubes/whatever from the stock one. The restrictive part of the stock is that big ole bar in the middle, so the Vortec is better, but might not be a "night and day" kinda change. Hey, every little thing heklps, right?
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Which one C&L 73mm or 76mm? | TwiLighTBluEGT | Windsor Power | 5 | 01-13-2003 04:35 PM |
| Installation of Vortec or Paxton...Is is easy? | Fox Hound | Windsor Power | 1 | 04-01-2002 09:15 PM |
| Vortec T Trim set up | redrider | Windsor Power | 1 | 08-25-2001 04:59 PM |
| which MAF? 73mm, 76mm, 80mm?? | acidangel316 | Windsor Power | 8 | 06-19-2001 02:37 PM |
| 73mm C&L | gray87GT | Windsor Power | 3 | 03-15-2001 01:06 PM |