Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-13-2001, 04:03 PM
|
#1 |
|
Registered Member
Join Date: Oct 2001
Posts: 8
|
Granada Disks Lower Ball Joint Problem (65 Mustang)
We just finished putting the granada disks on my 65 and ran into a little problem. The lower ball joint doesn't fit snugly and there isn't enough room for the castle nut to force it down like it normally would. Should I get an insert for the lower bj to snug it up or should I replace the lbj with one from a granada? Which one would be harder to do? Where do I get the inserts if that is your answer? TIA, Junkie
__________________
65 Mustang: 5 speed, 3.73's, STG3 GT-40 Irons, xe256hr cam, Perf. RPM, 625 cfm Carter AFB, Jacobs ignition 66 Mustang: Beat up front end, 289-2V, 3spd w/ slipping clutch |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Safety Issue 64 - 70 Mustangs | Mach1 Cobra Jet | Classic Mustangs | 20 | 07-11-2005 08:06 PM |
| 1988 2.3 Conv Mustang problem with Fan???? | Mustang 2.3 Conv | Small Ponies | 0 | 05-20-2003 07:58 PM |
| 99 mustang starting problem | lary22 | Modular Madness | 0 | 02-05-2003 03:25 AM |
| 1994 Mustang GT, idoling, problem | five.point.ohhh | Windsor Power | 5 | 09-20-2002 08:07 PM |
| Cold start problem ... 89 Mustang LX | bball88 | Small Ponies | 3 | 01-19-2002 03:31 PM |