Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-13-2001, 07:48 PM
|
#2 |
|
Registered Member
Join Date: Nov 1998
Location: Houston, Tx.
Posts: 3,887
|
You do mean the ball joint and not the outer tie rod end don't you? The lower ball joint from the mustang should fit the Granada spindle. The outer tie rod either needs a bushing in the spindle or the use of a Granada outer tie rod end.
Rev
__________________
'66 Coupe, 306, 350-375 HP, C-4, 13.07 e.t., 104.8 mph, 1/4 mi. O.B.C. #2 '66 coupe |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Safety Issue 64 - 70 Mustangs | Mach1 Cobra Jet | Classic Mustangs | 20 | 07-11-2005 08:06 PM |
| 1988 2.3 Conv Mustang problem with Fan???? | Mustang 2.3 Conv | Small Ponies | 0 | 05-20-2003 07:58 PM |
| 99 mustang starting problem | lary22 | Modular Madness | 0 | 02-05-2003 03:25 AM |
| 1994 Mustang GT, idoling, problem | five.point.ohhh | Windsor Power | 5 | 09-20-2002 08:07 PM |
| Cold start problem ... 89 Mustang LX | bball88 | Small Ponies | 3 | 01-19-2002 03:31 PM |