MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar Mark Forums Read

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 03-19-2001, 09:30 AM   #5
Capri306
Moderator
 
Capri306's Avatar
 
Join Date: Sep 1998
Location: Grand Rapids, Michigan, USA
Posts: 1,001
Post

If you were able to blow air into one side of the IAB and get air out the other side, with no power connected to it, I'd say it's bad. The stepper motor on the end of it opens the valve by the EEC giving it a certain 'duty cycle'. If it's stuck open, it's like a huge vacuum leak into the engine. I'd replace it, check for any other vacuum leaks, and reset the EEC (Click here to see how to reset idle correctly). The check engine light usually comes on when an on-demand code is set, like if there's a hard fault. I pull my codes for the hell of it every couple weeks. Like said above, check the EGR valve, too. There should be no vacuum (or barely detectable) at the EGR valve at idle. This is why it's pointless to disable EGR: it only opens (controlled by computer again) at cruising speeds. Never at idle, never at WOT, and never while cold. Oh well, hope I gave you some ideas. Good luck.

------------------
Capri306, Moderator, The Mustang Works Online
1979 Mercury Capri, 5.0L -- C4 -- 2.73
1987 Mustang LX Notch
Capri306 is offline   Reply With Quote
 


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:34 AM.


SEARCH