Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
11-17-2001, 03:43 AM
|
#1 |
|
Registered Member
Join Date: May 2001
Location: Oklahoma City OK USA
Posts: 236
|
Subframes is where I'd start, get rid of some of that flex. Then some attn. to the torque boxes. Have them welded up and possibly add some braces. Then some drag radials. You should notice a considerable difference just with that.
__________________
90 GT 25th Anni. Did the AOD to T-5 swap, SPEC clutch, Steeda Tri-Ax shifter, BBK 2½ inch off-road H pipe, Flows, BBK 70mm TB/EGR, Ford Racing aluminim driveshaft, 3.55's, welded subframes, Ram Air, 3 core radiator, NOS dry kit 75 shot, and a K&N filter. 12.9 @ 108 |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hooking up elec. fan, What to do about a coolant res.? | MattwantsSpeed | Windsor Power | 6 | 10-23-2002 11:44 AM |
| hooking up sub to home receiver :D | jj_jonathon | Audio, Security, & Electronics | 2 | 09-08-2002 01:42 PM |
| hooking up a/f and voltemeter gauges... | MineralGray02K | Modular Madness | 0 | 08-03-2002 11:36 AM |
| Hooking up Rollstop | Ares | Modular Madness | 10 | 02-21-2001 05:41 PM |
| Lod noise, bypass and hooking up | Dominick99GT | Special Production | 0 | 12-27-2000 06:00 PM |