Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-17-2001, 02:18 PM
|
#8 |
|
Registered Member
Join Date: Nov 2000
Location: So. Cal.
Posts: 244
|
Those seats are the 2001's. They are MUCH better than the 88's. The 88's sat up too high (the base was "thicker" from floor to seat) and they had the side bolsters and lumbar support which (I felt) made them uncomfortable.
The gauge cluster is the CNC aluminum unit made by JME Enterprises . I then put Autometer Phantom Gauges in
__________________
347 CHP shortblock, TFS TW, Stealth, 650 Holley, Flowtech hdrs, Dr. Gas X, 2 Chmbr Flowmaster, MSD 6AL-Dist.& SS coil, March serpentine pulley system, Richmond 6 spd, CFDF, Hyd. TOB, Currie 9" w/3.50, alum Drv Shft, susp mods, TCP subframes & tower braces, Trans Am Racing power dual master, 4 wheel disc, 17x8 Torqthrust II's Something up my sleeve  In a 66 coupe www.2mfffabshop.com |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| seat swap | 94snake | Classic Mustangs | 1 | 05-07-2003 04:02 PM |
| Front Suspension/Granada Swap | Vishnoff | Corner Carvers Delight | 0 | 04-07-2003 11:24 AM |
| Front end swap? | kahmi_ui | Windsor Power | 4 | 04-15-2002 02:57 AM |
| 1991 Back Seat Bracket??? | jz_mustang50 | Windsor Power | 0 | 10-07-2001 08:39 PM |
| Front Suspension Swap | Z28EATR | Windsor Power | 2 | 02-09-2001 02:26 PM |