Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-19-2001, 07:37 PM
|
#9 |
|
Registered Member
Join Date: Oct 1999
Location: Cincinnati, Ohio
Posts: 1,575
|
Just make sure that you have new heads bolts and all the GT-40's I have seen you need the head bolt washers. Make sure you DON'T put them on backwards. Mine went on perfect with no problems, everything lined up great. Good luck!
------------------ 87 GT, 4 inch cowl hood,17x9 Cobra R's/255/45's,GT-40 heads,long tubes headers,h-pipe,Flows,BBK cold air, Mass air,70mm MAF, 1.7's, 1" spacer,underdrive pulleys,Pro 5.0, King Cobra, Adj. fuel Reg., Lakewood Lift Bars,50/50's,subframes, 4.10's. Best time 13.012 Best MPH 104 Best 60' 1.816 Visit my site at: http://www.geocities.com/cobrar93_2000/MyPage.html |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone running 15x10 draglites on an 84 GT. | ciara | Windsor Power | 2 | 12-02-2003 02:31 AM |
| gt40 heads | BLOCKER | Windsor Power | 6 | 02-09-2003 11:01 PM |
| GT 40 iron heads | frank rymas | Windsor Power | 1 | 03-14-2002 02:09 PM |
| porting gt 40 heads | foxandfoe | Windsor Power | 0 | 06-17-2001 02:39 AM |
| GT40 P heads plugs | Shotgun28 | Windsor Power | 2 | 04-03-2001 06:31 AM |