Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-20-2001, 07:05 PM
|
#3 |
|
Registered Member
Join Date: Feb 2000
Location: wi
Posts: 62
|
switch
first the c4 was in the car when i bought it. Its a revese manual valve body with a 3800 stall behind a 300 hp. 302. The trans fluid is a little burnt so figure it should probably at least be gone through. With the stall speed behind the 302 its gonna be out rageous behind my 393, so figure on a new stall. Then there's the drivability issues would like to be able to drive the car to some off the big shows down south and not run 3500rpm the whole way. Anyway just considering right now thanks
__________________
[list=a] *85gt 66,000,8pt.cage ,weld in frame connectors,9inch/3.73 393 in process,afr185's,comp cams 282,spec stage 2 clutch,D&D tubular k-member,coil over all 4,steeda doouble adjustable uppers,pro3i lowers and caster camber plates[/list=a] |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5 speed conversion to AOD | ruquick | Windsor Power | 14 | 10-18-2004 08:44 AM |
| Six speed conversion for a 95 GT | Giddy Up | Windsor Power | 2 | 03-08-2002 05:20 PM |
| First ticket. Sucks, sucks bad. | zepherman | Blue Oval Lounge | 46 | 12-16-2001 07:24 PM |
| EFI conversion with Speed Density and a 351w? | PSI GUY | Windsor Power | 2 | 12-02-2001 11:13 PM |
| Speed density conversion | mustangLX92 | Windsor Power | 12 | 06-28-2001 01:49 PM |