info about drag suspension for a daily driver?

[Rick 91GT]

I have the Eibach drag launch kit with 70/30s up front and 50/50's in the back. Its cut a 1.604 60' on 26" x 11.5" ET STREETS, with the 4:30's I hope to go sub 1.50.

It doesnt handle that bad, but as stated above don't try to be Mario Andretti.

My car sits level maybe a little lower in the front even, just makes sure the springs are installed right and you won't have any problems, I believe Sky's settled down a bit after his install. I would go 70/30's over the 90/10's unless you plan to have a heavy motor up front, the 90/10's tend to keep the front end up a little higher creating a higher wind drag. If anything mine sits a little lower in the rear on the drivers side depending on how much air is in the spring.