© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-24-2001, 03:06 AM | #1 |
Registered Member
Join Date: Jun 2000
Location: Stillwater, OK
Posts: 107
|
Does the Eibach drag kit lower the car at all?
Hey guys, i was looking into lowering springs for my car, but i don't want to have the stiffness that comes along with them (for weight transfer at the strip). So my question is does the eibach drag kit lower the car at all, or does it just aid in the weight transfer? I'd really like to lower my car, the fender gap drives me nuts, but anyway. Thanks in advance.
------------------ 94 cobra, stock for now......... Quartermile times soon....... |
02-24-2001, 03:49 AM | #2 |
Registered Member
Join Date: Apr 1999
Location: Overland Park, KS, USA
Posts: 1,631
|
I haven't personal experience here, so my word isn't exactly gospel on this subject. I think the Eibach drag launch kit lowers the car a *little* bit. Probabl barely enough to notice. The main benefit there is for proper weight transfer, and some lowering springs can actually hurt you 1/4mi. times a tad. If all you want is some lowering springs, check around for the spring rates of different manufacturers. The springs with the lowest rate will be the softer springs.
------------------ 1984 1/2 GT350 (#842 Hatchback w/ T-tops), 302HO, Comp cams Xtreme Energy cam, Carter 625cfm carb, Weiand Stealth intake, MSD distributor, MSD coil, FMS 9mm wires, 1 5/8" MAC unequal shorties, 2 1/2" MAC Prochamber H-pipe, Flowmaster 2 chambers, KYBs, 16"x8" 4 lug Cobra Rs, Falken 245/45ZR16s |
02-24-2001, 04:01 AM | #3 |
Registered Member
Join Date: Jan 2001
Location: san diego, ca
Posts: 17
|
no the really dont. at first the car will sit higher. then they setle to stock hight. if you want drag sprigs and a low ride. get a coil over kit for the front struts and rear shocks and get drag weight springs with the kit. this way you can adjust the hight and still have weight transfer.
|
02-24-2001, 08:19 AM | #4 |
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
I added the drag launch kit and the 70/30 and 50/50 all at one time and my car dropped @ 1.5" all around. The kit will lower your car, I have just enough room to slide my big 3.5 ton Craftsman jack under it. It lowered all my friends cars as well even without the struts and shocks
------------------ My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98 |
02-24-2001, 04:14 PM | #5 |
I need 110mph Trap Speed!
Join Date: Feb 1999
Location: So, CA
Posts: 4,315
|
Hey Rick, Thanks, ive been tryin to get some first hand info on these. Does your car sit higher in front than in back now? I hate it when cars looks like that and someo people told me the Eibach setup does that. If not, I'm going to order it. 1.5" sounds good. Should be about where Im at now already, but with better traction
Skyler ------------------ -1989 Saleen Mustang #406-TFS Heads, E-303 Cam, Edelbrock Intake, and more. -Videos (MPEG)- 0-110MPH In car view (963k) All Throttle through 3 gears! (497k) Tire Smoking Burnout! (218k) |
02-24-2001, 08:09 PM | #6 |
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
Actually it sits a hair lower in the front, I think it is well worth the money
|
Thread Tools | |
Display Modes | Rate This Thread |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Eibach drag springs + Tokico drag struts | Greystang302 | Windsor Power | 6 | 01-01-2002 01:46 AM |
Eibach Drag Spring Rates | COG3164 | Windsor Power | 1 | 12-11-2001 06:21 PM |
Ride quality with Eibach Drag kit is... | SlowStang2 | Windsor Power | 3 | 10-18-2001 03:56 PM |
Eibach drag lauch kit has front wheel sitting higher in the front - please help | Stang_ROTY | Windsor Power | 9 | 09-01-2001 12:59 AM |
4cyl. Springs & Shocks, Or 50/50s, 90/10 & Eibach Drag Kit??? | BowTie Eater 5 Liter | Windsor Power | 3 | 04-13-2001 05:46 AM |