Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-21-2001, 10:51 AM
|
#1 |
|
Registered Member
Join Date: Nov 2001
Location: germantown MD
Posts: 283
|
Putting in new clutch. Anything left out?
I am finally going to put in my new clutch. My 85 still has its original clutch. I got FM King Cobra. I got a new flywheel, clutch disk, pressure plate, throw out bearing, clutch fork and cable. I got the cluthc pilot tool, all new arp bolts.
My question is, should I get a new pilot bearing. If so, any recommendations on where to get it or what brand. Another question. I heard this is a good time to replace the rear main seal. I heard that some have a 1 peice and some have a 2 piece seal. Does anyone know which it is for an 85 GT. Is there anything I am leaving out. BTW I'm doing it myself for the first time. Any tips would be appreciate. No matter how much I prepare for something I've never done before I always seem to run into something I wasn't expecting.
__________________
85 GT 4bbl roller cam 2 ch. Flowmasters, O/R H-pipe Performer intake and carb milodon water pump, FMS 9mm wires, aluminum driveshaft, king cobra clutch |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Putting in clutch pedal after starter install now produces very high pitched whine | crazypete | Windsor Power | 3 | 08-18-2003 08:51 PM |
| Loud "pop" after clutch install, won't go into gear.. | Chris_H | Windsor Power | 3 | 08-11-2003 06:24 PM |
| T-5 swap & cable clutch problem | LuvMyStang | Classic Mustangs | 0 | 03-19-2003 08:47 AM |
| Clutch Problems | blue302 | Windsor Power | 3 | 09-10-2001 01:37 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |