MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Reload this Page D&D Tubular K-member
Register FAQ Members List Calendar Mark Forums Read

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 12-29-2001, 05:36 PM   #1
Doctor DeBo
Registered Member
 
Join Date: Feb 2000
Location: Newnan, GA, UnitedStates
Posts: 83
Post D&D Tubular K-member
Anybody have any info on D&D K-members,are they any good?or are they a pain in the *** as far as compatability and mods to make them fit.
__________________
92LX 5.0 Hatch,4.10 gears Auburn Pro,Mosser axels,alum drive shaft AOD hi ratio gear set,3200 stall TCI conv,Bassani long tube headers/cats,2 chamber flow masters,2.5inch exhaust,331 stroker,alum GT40 heads ported,Omega 1.7 roller rockers,JE forged pistons,Eagle rods,E cam,GT40 upper/lower intake,70mm mass,73mm Pro M bullet,MSD ignition,Cartech fuel sys w/external Aeromotive fuel pump,30lb injectors,Vortech S trim,Tubular front end,D&D coil overs up front
Doctor DeBo is offline   Reply With Quote
 

« Previous Thread | Next Thread »

Thread Tools
Display Modes Rate This Thread
Threaded Mode Threaded Mode
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
K Member 65,dohc,project Classic Mustangs 0 10-06-2004 03:27 PM
K member Question techsan Windsor Power 3 03-20-2003 10:04 PM
tubular k member/ motor mounts? sn95gt19 Windsor Power 0 12-04-2002 12:05 PM
best tubular k member? PSI GUY Windsor Power 3 10-15-2001 03:46 PM


All times are GMT -5. The time now is 08:15 PM.

Archive - Top

SEARCH