Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-26-2002, 07:08 PM
|
#1 |
|
Registered Member
Join Date: Jul 2001
Location: West Bloomfield, MI
Posts: 391
|
do i need new springs???
im going to put on crane 1.7 RR on my 90 GT. the motor runs great, no problems with valve floating at all. it has 80,000mi. on it. my question is do i need to get new valve springs?
if you think so, why? and which ones would you recomend? how much lift does the stock cam have? and what would putting the 1.7RR put it at? thanks, adam
__________________
90 GT black/ grey leather ported GT-40 heads w/ 1.7RR, Cobra intake w/ ported lower, 24# injectors, 190LPH pump, 75mm Pro-M MAF, 65mm TB, K&N panel, BBK long tubes, Off road H-pipe, 2 ch. Flowmaster, Black magic fan, Kirban FPR, 180 deg. T-stat, 3.73's, Steeda Tri-Ax, 130 amp alt. Accell 8.8 race wires/cap/rotor, motorcraft plugs, Factory Five suspension, etc etc etc.... http://avbcon12.stangnet.com Last edited by avbcon12; 01-26-2002 at 07:26 PM.. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| stocks springs vs. lowering springs | GhettoPop | Windsor Power | 1 | 02-12-2004 07:08 PM |
| can I use hardtop springs in my vert? | tireburner163 | Windsor Power | 5 | 02-25-2003 02:46 PM |
| H&R springs or Eibach?? (replaing my Jamex Springs) | KB94GT | Modular Madness | 0 | 05-14-2002 07:44 PM |
| valve springs....questions | Old Guy with 87 GT | Windsor Power | 5 | 05-03-2002 06:36 AM |
| Springs | MDM | Windsor Power | 0 | 04-11-2001 06:53 PM |