Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-05-2002, 02:23 PM
|
#1 |
|
Registered Member
Join Date: Feb 2002
Location: Monterey, CA
Posts: 76
|
Cleveland heads
Are a set of Cleveland heads too big for a 289 engine with mods? I have a chance to get a free set of Cleveland heads, but those were meant for an engine that is considerably bigger than mine. Are they even compatible? If so, what problems should I forsee happening if I try to bolt them on? I also have a chance to get a pair 302 heads, would those be better for my car? I was thinking about just taking the 302 heads and have them bored out and port polished. I'm in the process of putting in a toploader or T5 tranny, after that I'm going to get a new differential, 8.8 with 3.55 or 3.73.
Given this configuration, what would you do? Thanks alot, Jason
__________________
67 Coupe 289, 2 1/4'' pipes w/ Flowmasters Edelbrock 600 cfm 4bbl carb, Edelbrock Airgap intake Hooker headers, MSD Ignition system Next: new tranny, T5 or Toploader |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|