Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-08-2002, 07:58 AM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Tampa, Fl
Posts: 16
|
Clutch pops after AOD to T5 swap
I recently had a guy do an AOD to T5 swap. I rounded all the parts an optioned to use new parts for the clutch quadrant/cable and clutch assembly. My problem is that when I press the clutch it sometimes (not always) makes a solid pop. The clutch works fine and clutches properly. Is it possible that I was sold a bad quadrant cable? I've looked for possible kinks, but there doesn't appear to be any. Any suggestions are highly appreciated...
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| '85 clutch swap problems, cable too long | bbutcher85710 | Windsor Power | 2 | 03-25-2004 08:22 PM |
| Loud "pop" after clutch install, won't go into gear.. | Chris_H | Windsor Power | 3 | 08-11-2003 06:24 PM |
| T-5 swap & cable clutch problem | LuvMyStang | Classic Mustangs | 0 | 03-19-2003 08:47 AM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |
| Cable clutch swap for old mechanical linkage, any ideas? | Giddy Up | Classic Mustangs | 6 | 10-28-2000 10:25 AM |