Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-19-2002, 12:51 PM
|
#1 |
|
Registered Member
Join Date: Jul 2001
Location: Seattle, WA
Posts: 381
|
Is this a project I could handle?!? (Intake, heads, cam...)
Hello,
I installed my exhaust and my cold air intake (very simple)...I have no experience with installing any of the three mentioned in the subject. I am just curious how involved of a project this would be. How long I would have to expect to spend working on it. And is a reasonable project for me to take on?!? I really want the gains I would get from these, but don't want to pay for installation  Also, are there any overview installation instructions on the web? Thanks, DoranW
__________________
What I have: 1990 Red Mustang 5.0 LX: [BBK X-Pipe]-[MAC Cat-Back Exhaust] [MAC Cold Air Intake]-[BBK Equal Shorties] [3.55 Gears]-[Cobra Intake Manifold (Upper and Lower] [E-303 Cam]-[Granetelli Mass Air Flow Sensor] [Front and rear sway bars]-[New black carpet and seats.] [Adjustable Fuel Regulator]-[T5 Conversion w/ K. Cobra Clutch/Hurst STS] [Cobra Throttle Body]-[130A Alt. Conversion] Thinking about: Aftermarket Heads! Vortech A-Trim |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Best heads, intake, cam setup?? | project 5.0 | Windsor Power | 11 | 02-25-2003 07:48 PM |
| Heads, Intake | OneBad95 | Windsor Power | 0 | 07-22-2002 12:05 AM |
| Cobra Heads And Intake Swap | surfbeast | Modular Madness | 1 | 03-12-2002 05:41 PM |
| GT-40P heads and intake question | ex-lt1-guy | Windsor Power | 1 | 03-12-2002 09:55 AM |
| It's May, still no new heads or intake by other manufacturers? | Red Mustang Gt 46 | Modular Madness | 7 | 05-08-2001 05:22 PM |