Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-28-2002, 09:38 AM
|
#1 |
|
Registered Member
Join Date: Jan 2001
Location: Clayton, CA USA
Posts: 116
|
Aluminum Intake Prep
I'm in the process of swapping out my 289 for a 5.0 crate motor. Right now I'm gathering parts and getting them ready to install on the new motor.
I have an Edelbrock Performer on my 289 now. After a little over 2 years, it does not look great. Aluminum seems to retain all grease and oil spots. I've decided to go with an Edelbrock Performer RPM intake for the new motor. Is there anything that I can prep it with to keep it looking somewhat new?
__________________
'68 convert, 5.0 GT-40 Crate motor, C-4, Tri-Y headers, 3.25 rear gears |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Intake with NITROUS!!!???? | NOSstang08690 | Power Adders | 9 | 09-09-2003 07:05 AM |
| PHENOLIC or ALUMINUM intake spacer? | 96_4.6 | Modular Madness | 15 | 07-20-2003 03:06 PM |
| HELP!!! oil in intake, what to do?? | bosco | Windsor Power | 4 | 02-03-2002 05:02 PM |
| OIL IN INTAKE almost sure from 'pcv' | QUIN | Windsor Power | 8 | 03-09-2001 01:58 PM |
| Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |