Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-28-2002, 07:41 PM
|
#1 |
|
Registered Member
Join Date: Jul 2001
Location: West Bloomfield, MI
Posts: 391
|
annoying valvetrain tick
i have 1.7RR's on my GT-40 heads and after doing so i have a tick on the passenger side. i know its on the number 4 cylinder because for some reason it seemed to want 2 shims.... that was the closest i could get it.
is it possible to get a tick if they are too tight. meaning the pre-load is too much... i know it can happen if it is not enough (valve float). but this happens at all RPM's. obviously it gets faster as the RPM's climb. what should i do? what would be the best way to adjust them? because it has 2 shims and only some of the others have 1 should i take a shim out to see if that helps? i have no idea why one cylinder would be that far out... please help! thanks, adam
__________________
90 GT black/ grey leather ported GT-40 heads w/ 1.7RR, Cobra intake w/ ported lower, 24# injectors, 190LPH pump, 75mm Pro-M MAF, 65mm TB, K&N panel, BBK long tubes, Off road H-pipe, 2 ch. Flowmaster, Black magic fan, Kirban FPR, 180 deg. T-stat, 3.73's, Steeda Tri-Ax, 130 amp alt. Accell 8.8 race wires/cap/rotor, motorcraft plugs, Factory Five suspension, etc etc etc.... http://avbcon12.stangnet.com |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| tick tick tick tick | sdd228 | Windsor Power | 10 | 07-17-2003 02:42 PM |
| Max HP With Stock Block(302)? | pac663 | Windsor Power | 8 | 07-16-2002 04:52 PM |
| Help with a engine tick any thoughts? | fireman442 | Classic Mustangs | 4 | 07-14-2002 02:45 PM |
| Annoying Tick when warm | StreetStang37 | Windsor Power | 2 | 06-12-2002 11:14 PM |
| Pneumatic Valvetrain! | gtsr515 | Windsor Power | 17 | 05-12-2002 03:14 AM |