Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-05-2002, 09:59 PM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Long Island, NY
Posts: 71
|
Picture of my Built shortblock & P&P heads
The block has the cobra crank, Manley H-beam rods, JE Forged 17cc pistons, and ARP fasteners. The compression is about 8.8:1 I believe.
__________________
99 Silver GT Auto DTA Built Engine w/P&P heads, TDC Turbo (T-76), Built 4R70W, PI Multi-Disc 3200 T/C, Eaton 31 Spline Carrier, Strange 31 Spline Axles, Aeromotive 1000 HP fuel system, 66lb injectors, MSD DIS4, Accel DFI Gen VII & Mac 3" cat-back. Built by Jade Performance Best on Nitto D/Rs 11.698 @ 120.898 @ 12 psi (built block) Best on Slicks 10.922 @ 122.95 (stock longblock) |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What kind of Windsor heads? | vetteeatr | Windsor Power | 11 | 10-28-2001 03:43 AM |
| For whoever it was considering using stock ported heads | 2FastLX | Windsor Power | 5 | 10-11-2001 01:53 PM |
| is there any difference between 351C heads and 351M heads | tireburner163 | Windsor Power | 7 | 03-09-2001 09:26 PM |
| Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |
| Which heads are beter? | patman | Classic Mustangs | 3 | 12-02-1999 03:42 AM |