

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Jul 2002
Location: Houston, Texas
Posts: 13
|
![]() I'm rebuilding this '65 200ci motor, and I'm almost done. But there's this, what appears to be a water outlet that I'm not certain about. And it's been a couple of months since I pulled the motor so I don't recall what goes in this hole (go ahead, I can take the jokes).
Anyway, at the front edge of the block, drivers side, behind the lower radiator hose inlet. About a 1" diameter hole, with two bolt holes, and a bracket that attaches to the power steering unit also attaches here. e-mail me directly (stingray@houston.rr.com) if you want a pic of what I'm talking about. I'm stumped, and I don't have any spare parts left over that look like they'd fill the hold, and I certainly don't have any reciprocal water outlets that would accept water from here. As Always......... Wendell |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Possible oil in water?? | Simi Stang | Windsor Power | 1 | 01-24-2003 02:55 PM |
P/S bracket and hose | mike34cpe | Classic Mustangs | 0 | 11-04-2002 08:58 PM |
Free Horsepower, but at what cost?? | 71grande | Classic Mustangs | 13 | 09-21-2002 05:07 PM |
Water pump....AC Bracket problem | Jimmy Page | Classic Mustangs | 3 | 07-28-2001 01:54 PM |
Pulleys, water pump, and fan clutch | dinomite | Windsor Power | 5 | 05-26-2001 09:00 AM |