Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-21-2001, 07:49 PM
|
#1 |
|
Registered Member
Join Date: Feb 1999
Location: Boston, Ma
Posts: 52
|
Steel Bearing Retainer!
Iam looking for a steel bearing retainer for my T5 tranny, for those who may call it something else it is the sleve that goes on the input shaft, stock its cast aluminum and i know there is a steel one out there somewhere, if anyone can point me in the right direction i would appreciate it!
Thanks ------------------ 1989 mustang GT mildly modified,windsor sr.heads,TRW 10:90 flat top pistons,Flow tech headers, Manley vlaves, flowmaster exhaust,pro dumps,hotchkins upper and lower control arms, ebiach springs,koni shocks,pro5.0shifter,chrome moly weld in subframe connectors,new interior now a 2 seater,8pt chrome moly roll bar and HAL K-member,coilovers,castercambers,Auburn Pro Locker,3:73's Strange SS racing Splines 31 tooth c-clip eliminators. Mass Mustang Club |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| T5 hard to shift after replacing bearing retainer | Merlin76 | Windsor Power | 8 | 02-20-2004 10:22 PM |
| Stock steel bearing retainer? | Merlin76 | Windsor Power | 1 | 04-13-2003 08:42 AM |
| Shakey from the start?¿ | GreenPony | Windsor Power | 13 | 02-11-2002 08:53 AM |
| Difficulty of steel TOB retainer install?? | JRowlette | Windsor Power | 0 | 11-08-2001 09:22 PM |
| T-5 Bearing Retainer | 86StangGT | Windsor Power | 3 | 03-20-2001 12:07 PM |