Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-01-2001, 12:06 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Sterling Hgts, MI, U.S.
Posts: 64
|
Oil leaking from pan after Vortech install
I was installing oil drain-back fitting. The instructions say to clean around where your going to put the hole. Well there's a leak now about 1" away from fitting in the middle of nowhere. A friend of mine tried to clean his pan and his leaked through pan too. Is there a fix for this like JB weld or something? A guy from work told me about some marine stuff he used on his pan. I would normally use this as an excuse to buy a canton or such, but I have 351 project that I will get a nice pan for. Should I just put in new stock pan ($59 from summit) or chrome stock ($69 from summit)?
------------------ 90LX, T-5, Vortech V2-SQ, Holley, Twisted Wedge Stage1, X-303 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vortech Supercharger | -viscid-01-GT- | Modular Madness | 5 | 05-09-2003 11:53 AM |
| New Gears, Install, and Questions | B2r3y | Windsor Power | 6 | 02-21-2003 05:00 PM |
| cheap mafs at vortech | 7up | Windsor Power | 1 | 02-05-2002 03:14 PM |
| A Question for 94-95 owners concerning 1.7RR INSTALL | SlowStang2 | Windsor Power | 6 | 09-22-2001 06:39 PM |
| Vortech Install | Scott99GT | Modular Madness | 3 | 06-21-2000 09:55 AM |