86gt Alignment

MJ86GT · 05-09-2003, 07:35 AM

Installed Ford Racing caster camber plates on my 86gt with sn95 spindles, cant get +3 degrees caster. It will only go to +1.8 with -.7 camber. We can get -1 camber but it drops the caster lower because of the strut opening being round. Steeda says that I wont be able to get anymore caster because of it being an 86 or earlier. Anybody have any ideas? Maximum Motorsports says to notch the top of the strut towers which is fine but seems like there should be enough adjustment with out doing this. Everything underneath is centered up and aligned.

Shaggy · 05-09-2003, 07:15 PM

What you are seeing is what i consider typical. Your car probaly is straight but ford didn't design the strut tower to have much adjustment so you have to "redesign" it.

drudis · 05-13-2003, 11:28 AM

I got out a carbide tip... and MADE the strut tower opening bigger.

I get -2.7 camber, 5 caster, and 1/16 toe out.

05-09-2003, 07:35 AM	#1
MJ86GT Registered Member Join Date: Mar 2003 Posts: 32	86gt Alignment Installed Ford Racing caster camber plates on my 86gt with sn95 spindles, cant get +3 degrees caster. It will only go to +1.8 with -.7 camber. We can get -1 camber but it drops the caster lower because of the strut opening being round. Steeda says that I wont be able to get anymore caster because of it being an 86 or earlier. Anybody have any ideas? Maximum Motorsports says to notch the top of the strut towers which is fine but seems like there should be enough adjustment with out doing this. Everything underneath is centered up and aligned.

05-09-2003, 07:15 PM	#2
Shaggy Registered Member Join Date: Feb 1999 Location: Houston,TX Posts: 466	What you are seeing is what i consider typical. Your car probaly is straight but ford didn't design the strut tower to have much adjustment so you have to "redesign" it. __________________ A good plan, violently executed now, is better than a perfect plan next week. George S. Patton, General (1885-1945)

05-13-2003, 11:28 AM	#3
drudis Moderator Join Date: Dec 1999 Location: Livonia, MI, USA Posts: 1,194	I got out a carbide tip... and MADE the strut tower opening bigger. I get -2.7 camber, 5 caster, and 1/16 toe out. __________________ Darius Rudis, Moderator Corner Carvers Delight 1989 Mustang LX - Open Track Car http://www.dariusrudis.com

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
8.8 or 7.5 in 86GT??	Comatose	Windsor Power	9	06-09-2004 10:08 PM
Front End Alignment	orlowted	Classic Mustangs	5	03-26-2004 08:38 AM
88-91 CV Chassis Alignment Specs	door64	Blue Oval Lounge	0	03-23-2002 06:36 AM
Alignment Problems......	Her99GT	Modular Madness	7	01-30-2002 08:23 AM
Do I need to use pressure plate alignment dowels with clutch install?	TROYXTROY	Windsor Power	4	01-25-2001 02:12 PM