Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-06-2003, 12:42 AM
|
#1 |
|
Registered Member
Join Date: Aug 2003
Location: CA
Posts: 7
|
5.0L non HO to HO
I have recently swapped my non HO EFI motor for an HO EFI and found my new motor has a new firing order. I am using the original intake,fuel rail and injectors. I assume my injectors will not be pulsing at the right time. Can I move the injector connectors to the proper injectors to correspond to the new firing order? Will this work or do I have to hunt down another EEC unit ?The old firing order is: 1 5 4 2 6 3 7 8
The new firing order is 1 3 7 2 6 5 4 8 This is my plan: injector connector 5 to injector 3 connector 4 to injector 7 connector 3 to injector 5 connector 7 to injector 4 Will this work and if not why not? Thanks for any help TOM |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2.3L to 5.0L | jordan456789 | Small Ponies | 5 | 04-10-2009 12:17 PM |
| 5.0L ---> 5.0L conversion | Rodoggx | Windsor Power | 8 | 11-25-2002 10:03 PM |
| 5.0L vs 4.6L comparison | tchm | Windsor Power | 3 | 07-22-2001 09:07 PM |
| Tricks for 5.0L in 96 Explorer AWD | scott93gt | Windsor Power | 0 | 07-02-2001 08:05 AM |
| Buying a 5.0L mustang | V6 bandit | Windsor Power | 4 | 03-29-2001 10:40 AM |