Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-29-2003, 10:33 PM
|
#1 |
|
Registered Member
Join Date: May 2001
Location: Antioch, CA 94521
Posts: 181
|
I'm thinking it's a Valve issue???
My car hits a wall at 5400 rpms. I thought it was possible the VSS. I resolve the speedo issue and it didn't help. I thought it may be the chip but I had the rev and speed limiters raised on them by Byron already who too says there's nothing wrong with my calibration.
I'm getting a compression and leak down test tomorrow. Could be a Valve Float problem??? I have a Lunati cam (L51014) and Twisted Wedge heads that have been on the car for 2years now. My rwhp numbers from 10/11 seemed pretty low to me at 239. If it is a Valve problem, how hard are the spring to replace and how much does something like that usually cost on a 94 GT? Thanks, Tony
__________________
N/A 94 GT vert w/aode...12.19 @110 w1.67 60' Some bolt ons |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| valve problem | pearlgt40 306 | Windsor Power | 3 | 07-05-2003 01:21 AM |
| Why not radius the valve and seat? | fiveohpatrol | Windsor Power | 4 | 07-02-2002 09:11 PM |
| Proportioning Valve | MidniteWrider | Classic Mustangs | 1 | 07-11-2001 09:14 AM |
| Valve Springs & Roller Rockers | StreetStang37 | Windsor Power | 4 | 04-17-2001 03:54 AM |
| PCV Valve what the ?@#$@#$@$ | Chevyguy | Windsor Power | 3 | 04-11-2001 08:01 PM |